SS
SATTAROV SHOKHRUKH
17 часов назад
Всё супер, быстро, за пару часов сделали
3D Printing·for universities
3D printing for universities
3D printing for universities is mostly ordered by student councils, faculties and clubs. The pluses are simple: a raised emblem on a hoodie, a tactile accent on the chest, a capsule for the semester. This is TPU 3–8 mm high, not foam puff ink. We leave the section sports kit without a patch: sweat and frequent laundry are no friend to volume.
Segment task
In autumn — a hoodie with a 3D club emblem; in spring — a festival tee, but the raised element stays a spot. A full-colour poster on a tee is DTF; the patch is a separate layer. A size pre-order is collected; the file is checked with officers before print. Faculty brand colour is locked to the TPU mix. The patch stays on the chest, not across the back: the cloth stretches.
When the method fits
3D fits a club hoodie when you need a readable silhouette — a crest, an abbreviation, a faculty symbol. Puff on a hoodie looks softer and lower (1–2 mm); TPU gives 3–8 mm relief. Volume is not put across the whole back. Section kit stays flat.
How to order
Send the emblem file, a size table from the pre-order and the event date. Name hoodie or tee, and where to sit the patch. We make a test transfer on a cloth sample if the design is disputed.
Handover
The run is ready for pickup in Sergeli or delivery across campus and the city. Large orders for an event date we lock to the shop schedule in advance.
YouTube Shorts
Watch the process
3D printing on apparel: flexible TPU/Flex pieces bonded to fabric — real height, not foam ink.
Real volume on fabricFlexible, won't breakEven just 1 piece
FAQ
For a raised emblem on a club hoodie or limited merch for an event — yes. Section kit and a poster across a tee — DTF or flat. 3D stays a spot. TPU 3–8 mm, not puff.
From a few dozen by pre-order to officers. Each semester is a new file; the old one is not reprinted. A size reprint from the pre-order.
A cotton or blend hoodie, sometimes an event tee. The patch on the chest or shoulder — not across the back. The TPU mix is matched to fleece colour.
30 °C, inside out. No drum dry and no ironing on the patch.
Pickup in Sergeli or delivery across campus and the city. For a festival date we lock the schedule in advance after the file is signed off.
Other methods for Universities
3D Printing
3D Printing
Ready for your artwork
Your design — on the same kind of garment
Not a mockup render — real apparel with real print, shown from the front and the side. Your logo, illustration or photo lands cleanly on t-shirts, hoodies, polos or workwear.
3D printing for universities
Send the artwork — we’ll say if this method fits the run and fabric.
Find it faster
Service first, then city or who it’s for
Two different sections: by city — prices and delivery; who it’s for — café, factory, school. They are not on one page.