SS
SATTAROV SHOKHRUKH
17 часов назад
Всё супер, быстро, за пару часов сделали
3D Printing·for tour companies
3D printing for tour firms
3D printing for tour firms is mostly ordered by agency directors. The pluses are simple: a raised mark on a cap that reads in a group photo, a tactile accent on the visor, a seasonal capsule for guides. This is TPU 3–8 mm high, not foam puff ink. We do not cover a dusty route tee with a patch — volume is saved for the cap and a chest accent.
Segment task
In spring they replace worn caps; in autumn they reprint for new staff. The agency logo sits on the front panel of the cap; on a polo — a smaller duplicate on the chest if needed. Sand or blue twill holds a press better than thin cotton. The file is kept for the whole season. A slogan on the polo back is a separate flat method. The run is counted from staff on routes, not from the whole company at once.
When the method fits
For a tour firm, 3D is about a cap and a compact chest accent: a guide is visible from far off, the mark does not blend into a flat print. Puff on a polo will not replace a firm silhouette on a visor: that is 1–2 mm of ink, this is 3–8 mm of polymer. A wide back print is not covered with a patch.
How to order
Send the agency logo, cap and polo counts by size, and kit colour for the season. Say whether you need one patch size on both garments or two. We lock relief height to cap twill.
Handover
Pickup from production in Sergeli or a courier across Tashkent. We pack caps apart from polos so visors are not crushed.
YouTube Shorts
Watch the process
3D printing on apparel: flexible TPU/Flex pieces bonded to fabric — real height, not foam ink.
Real volume on fabricFlexible, won't breakEven just 1 piece
FAQ
On a seasonal cap and a compact chest accent — yes, the patch reads in sun and in a group photo. On a field tee — no. This is TPU 3–8 mm, not puff.
By the number of guides and drivers on routes — usually from ten to a few dozen sets. In spring they replace wear; in autumn they reprint for new hires. One file for the whole season.
Five-panel caps and, if wanted, a smaller patch on a polo chest. The patch sits on the front panel of the cap. Twill holds a press better than thin cotton. A slogan on the back is a flat method.
Polo — 30–40 °C inside out, no dryer on max. A cap does not go in the drum — clean by hand, do not scrub the patch with a brush. Do not iron on the relief.
Collect in Sergeli or receive across Tashkent. Caps and polos we pack separately. To the region — freight after we agree.
Other methods for Tour companies
3D Printing
3D Printing
Ready for your artwork
Your design — on the same kind of garment
Not a mockup render — real apparel with real print, shown from the front and the side. Your logo, illustration or photo lands cleanly on t-shirts, hoodies, polos or workwear.
3D printing for tour firms
Send the artwork — we’ll say if this method fits the run and fabric.
Find it faster
Service first, then city or who it’s for
Two different sections: by city — prices and delivery; who it’s for — café, factory, school. They are not on one page.